Home > News Center > Industry News

News Center

Related news

No search results found!

What's the difference between metal mould and automobile stamping mould for raw materials?
2021-05-11 15:52:17

Cold stamping of stamping parts, in terms of professional terms, refers to the use of press on the punch to apply certain pressure on the material, to make it separate or plastic deformation, so as to obtain the desired finished products. In general, punching and bending are two processes, which are punching first and bending, so as to process the CNC punch. However, in some special cases, it is necessary to bend before punching.

For automobile stamping parts, because it is website products and keywords, so in the learning requirements, it is to achieve comprehensive and specific. Therefore, the knowledge content and related difficult problems are all involved, and none of them can be missed. So, based on this, we will start to do it immediately to improve the efficiency of our study.

What is the flow in the measurement of the tool for the automobile stamping parts? In addition, which parts of the car have four-step stamping process?

If the stamping parts of automobile are tested, then the English language of flush in the measurement of its inspection tools is the plane inspection. In the automobile parts, there are four-step stamping process, which are for some large covers, and they are all automobile stamping parts.

Is there any difference between stamping die and metal stamping die in automobile stamping parts?

If the stamping die in automobile stamping parts is compared with the metal stamping die, then, the two are different, because, for the former, there are many technical requirements of a-plane, and for the latter, there is no requirement in this respect, so this conclusion will be drawn. Therefore, the difference between the two is mainly in the technical requirements.


Automotive stamping parts


What are the specific requirements for the stamping parts of automobile in raw materials?

The specific requirements of automobile stamping parts on raw materials are as follows:

Raw materials of stamping parts shall be certified by quality, and they shall meet relevant technical requirements, otherwise, they cannot be used. In addition, some corresponding analysis or test work can be carried out to check the material performance and whether there is any defect problem, so as to judge whether it is available. Moreover, if necessary, the re inspection of raw materials can be carried out to ensure that there is no loss.


KEY WORDS

Auto Body Parts,Sheet Metal Body Parts,Auto Parts Manufacturer

CONTACT US

Phone:+86-15366916688
Xinggang Avenue NO.6,Genggeng Industrial Zone,BaoYing Couty,JiangSu Province,China.